Measuring and Modeling Quality
513-771-7710

Our ISO/IEC 17025 Certification

Gauge Inspection and Certification

With the emergence of higher reliability and traceability requirements, an ISO/IEC 17025 certified 3rd party inspection service is essential in assuring and documenting gauge certification to today’s industry standards as well as your own product quality standards.

At 3D Engineering Solutions, we not only have the ISO accreditations needed to perform fully dimensioned gauge inspections at your site, but also the expertise to create certifiable reports that enhance documentation and audit capabilities.

What is ISO/IEC 17025?

ISO/IEC 17025 is the main standard used by testing and calibration laboratories. There are many commonalities with the ISO 9000 standard, but ISO/IEC 17025 adds in the concept of competence to the equation. And it applies directly to those organizations that produce testing and calibration results.

There are two main sections in ISO/IEC 17025 — Management Requirements and Technical Requirements. Management requirements are primarily related to the operation and effectiveness of the quality management system within the laboratory. Technical requirements address the competence of staff, methodology and test/calibration equipment.

Laboratories use ISO/IEC 17025 to implement a quality system aimed at improving their ability to consistently produce valid results. It is also the basis for accreditation from an Accreditation Body.

3D Engineering Solutions
10597 Chester Road
Cincinnati, Ohio 45215
513-771-7710
©2015 3D Engineering Solutions   |   Privacy Policy   |   Terms & Conditions   |   Site Map